Cisco 3750 - Catalyst EMI Switch, Справочник по командам

Страница: 1015 / 1154

B-43
Catalyst 3750 Switch Command Reference
OL-8552-07
Appendix B Catalyst 3750 Switch Debug Commands
debug platform etherchannel
debug platform etherchannel
Use the debug platform etherchannel privileged EXEC command to enable debugging of
platform-dependent EtherChannel events. Use the no form of this command to disable debugging.
debug platform etherchannel { init | link-up | rpc | warnings }
no debug platform etherchannel { init | link-up | rpc | warnings }
Syntax Description
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
Usage Guidelines The undebug platform etherchannel command is the same as the no debug platform etherchannel
command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the
session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands
init Display EtherChannel module initialization debug messages.
link-up Display EtherChannel link-up and link-down related debug messages.
rpc Display EtherChannel remote procedure call (RPC) debug messages.
warnings Display EtherChannel warning debug messages.
Release Modification
12.1(11)AX This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.