20
Step 3
Enter a hostname for the router (this example uses
3745
):
Configuring global parameters:
Enter hostname [Router]:
3745
The enable secret is a password used to protect access to privileged EXEC and configuration modes. This
password, after entered, becomes encrypted in the configuration.
Step 4
Enter an enable secret password. This password is encrypted (more secure) and cannot be seen when viewing the
configuration:
Enter enable secret:
xxxx
The enable password is used when you do not specify an enable secret password, with some older software
versions, and some boot images.
Step 5
Enter an enable password that is different from the enable secret password. This password is
not
encrypted (less secure)
and can be seen when viewing the configuration:
Enter enable password:
xxxx
The virtual terminal password is used to protect access to the router over a network interface.
Step 6
Enter the virtual terminal password, which prevents unauthenticated access to the router through ports other than the
console port:
Enter virtual terminal password:
xxxx
Step 7
Respond to the following prompts as appropriate for your network:
Configure SNMP Network Management? [yes]:
yes
Community string [public]:
Step 8
A summary of the available interfaces is displayed:
Note
The interface numbering that appears is dependent on the type of Cisco modular router platform and on the
installed interface modules and cards.
Current interface summary
Controller Timeslots D-Channel Configurable modes Status
T1 3/0 24 23 pri/channelized Administratively up
T1 3/1 24 23 pri/channelized Administratively up
Any interface listed with OK? value "NO" does not have a valid configuration
Interface IP-Address OK? Method Status Protocol
FastEthernet0/0 unassigned NO unset up down
FastEthernet0/1 unassigned NO unset up down
Step 9
Select one of the available interfaces for connecting the router to the management network:
Enter interface name used to connect to the
management network from the above interface summary:
fastethernet0/0
Step 10
Respond to the following prompts as appropriate for your network:
Configuring interface FastEthernet0/0:
Use the 100 Base-TX (RJ-45) connector? [yes]:
Operate in full-duplex mode? [no]:
yes
Configure IP on this interface? [yes]:
IP address for this interface:
10.1.1.1
Subnet mask for this interface [255.0.0.0] :
255.255.0.0
Class A network is 10.0.0.0, 16 subnet bits; mask is /16
