Cisco 3310 Mobility Services Engine, Руководство по началу работы

Страница: 38 / 60

5-2
Cisco 3310 Mobility Services Engine Getting Started Guide
OL-17304-02
Chapter 5 Initial Configuration
Requirements
Cisco WCS Requirements
Cisco WCS 5.1 (or later) or an external FTP server is required for mobility services engine software
updates.
Note Cisco WCS uses an internal FTP server. Third-party FTP servers cannot run on the same workstation as
the Cisco WCS because they use the same communication port.
Cisco Controller Requirements
Cisco wireless LAN controllers installed with releases 5.1 (or later) or 4.2.130 (or later) can
communicate with the mobility services engine.
Note
Please refer to the Release Notes for the Cisco 3310 Mobility Services Engine for software release
5.1.26.0 for compatibility by release between the mobility services engine and Cisco WCS and controller
releases at the following link:
http://www.cisco.com/en/US/products/ps9742/tsd_products_support_series_home.html
System Configuration Parameters
Obtain these parameters from your network administrator:
• A host name for the mobility services engine
•
A broadcast address for the mobility services engine
• An IP address for the Ethernet-0 (eth0) port (located on the mobility services engine back panel)
•
A net mask for the Ethernet-0 IP address
• An IP address for the Ethernet-0 default gateway
•
An IP address for the Ethernet-1 (eth1) port (mobility services engine back panel) (installation
optional)
• A net mask for the Ethernet-1 IP address (only required if the port is used)
•
An IP address for the Ethernet-1 default gateway (only required if the port is used)
Note
Either the Ethernet-0 or Ethernet-1 port can be used to transmit location updates to Cisco WCS.
However, the Ethernet-0 port is generally configured to communicate with Cisco WCS and the
Ethernet-1 port is generally used for out-of-band management. Both ports are configured as part of the
installation script described in the
“Configuring the Mobility Services Engine” section.