The cabling details for the Cisco 1601−R are as follows:
Console
The console cable is a rolled RJ−45 , the CAB−1600−CON=.
Ethernet
On the 1601−R router, there is one functional port for either the 10Base−T (RJ−45) or AUI (DB−15). The
cable details are the CAB−ETH−S−RJ45= Yellow Cable for Ethernet, Straight−through, RJ−45, 6 ft
Synchronous/Asynchronous Serial
On the 1601−R router, there is one DB−60 Synchronous/Asynchronous serial port.
Asynchronous
Asynchronous serial cables are used to support the following WAN protocols:
Point−to−Point Protocol (PPP)
•
Serial Line Internet Protocol (SLIP)
•
Asynchronous serial interfaces supported on the Cisco 1601−R and WIC−1T card require the following type
of cabling:
EIA/TIA−232
•
Individual cable options are:
CAB−232MT: EIA/TIA−232 male DTE interface, 10 ft (3 m)
•
CAB−232FC: EIA/TIA−232 female DCE interface, 10 ft (3 m)
•
Synchronous
Synchronous serial cables are used to support the following WAN services and protocols:
Frame Relay
•
X.25
•
Switched Multimegabit Data Service (SMDS)
•
Point−to−Point Protocol (PPP)
•
High−Level Data Link Control (HDLC)
•
Link Access Procedure, Balanced (LAPB)
•
IBM Systems Network Architecture (SNA)
•
Synchronous serial interfaces supported on the Cisco 1601 R and WIC−1T card require the following types of
cabling:
EIA/TIA−232
•
