Cisco 12010 series, Руководство по установке и настройке

Страница: 140 / 378

Chapter 3 Installing the Router
Reinstalling Components After Installing the Chassis
3-32
Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide
OL-11496-01
Reinstalling the Blower Module
Use the following procedure to reinstall the blower module in the chassis.
Step 1 Install the blower module into the chassis ( Figure 3-23 ):
a.
Lift the blower module (with two hands) and slide it halfway into the module
bay.
b. Slowly push the blower module into the chassis until it mates with the
backplane connector at the back of the module bay.
Caution
To prevent damage to the connectors, do not use excessive force when inserting
the blower module into the chassis.
c.
Tighten the captive screws on the blower module to secure it to the chassis.
Figure 3-23 Installing the Blower Module
122100
AC
T
0
DO
WN LOOP
RA
LA
CDHNT
CD
TX
0
RX
TX
1
RX
DO
WN LOOP
RA
LA
CDHNT
CD
TX
0
RX
TX
1