3-17
Cisco 10000 Series Router SIP and SPA Hardware Installation Guide
OL-13838-02
Chapter 3 Cisco 10000 Series Router Shared Port Adapters
1-Port 10-Gigabit Ethernet SPA Overview
1-Port 10-Gigabit Ethernet SPA LEDs
The 1-Port 10-Gigabit Ethernet SPA has two LEDs, an ACTIVE/LINK LED for the port and a STATUS
LED, as shown in
.
Figure 3-3
1-Port 10-Gigabit Ethernet SPA Faceplate
describes the 1-Port 10-Gigabit Ethernet SPA LEDs.
1-Port 10-Gigabit Ethernet SPA XFP Optical Transceiver Modules, Connectors,
and Cables
The 1-Port 10-Gigabit Ethernet SPA supports the following types of optical transceiver modules:
•
Single-mode short-reach (SR) XFP module—XFP-10GLR-OC192SR
•
Single-mode intermediate-reach (IR) XFP module—XFP-10GER-OC192IR
Cisco Systems qualifies the optics that are approved for use with its SPAs. As of the above-listed small
form-factor pluggable (XFPs) are the only optical transceiver modules qualified for use.
Use a single-mode optical fiber that has a modal-field diameter of 8.7 ±0.5 microns (nominal diameter
is approximately 10/125 microns) to connect your router to a network.
XFP Connections
The XFP-10GLR-OC192SR and XFP-10GER-OC192IR XFP modules include an optical transmitter
and receiver pair integrated with Clock and Data Recovery (CDR) integrated circuits. The XFP modules
provide high-speed serial links at the rate of 10.3125 Gbps (10 Gigabit Ethernet) on single-mode fiber
1
ACTIVE/LINK LED
2
STATUS LED
ST
ATUS
122151
ACTIVE/LINK
SPA-1X10GE-L-V2
1
2
Table 3-2
1-Port 10-Gigabit Ethernet SPA LEDs
LED Label
Color
State
Meaning
ACTIVE/LINK
Off
Off
Port is not enabled by software.
Green
On
Port is enabled by software and the link is up.
Amber
On
Port is enabled by software and the link is down.
STATUS
Off
Off
SPA power is off.
Green
On
SPA is ready and operational.
Amber
On
SPA power is on and good, and the SPA is being configured.
