CIS
-
CRS112
-
8P MANAGED L2
-
L3 NETWORK SWITCH
PRODUCT MANUAL
8. PoE Information and Settings
PoE
-
Out Modes:
Auto
-
on mode
If auto
-
on is selected on a PoE
-
Out interface, then the port operates in this strict order:
•
The switch checks for resistance on the connected port. If the detected resistance range is between (3k
Ω
to 26.5k
Ω),
the
power is turned on.
•
When power is applied, the switch continuously checks if the overload limit is reached, or if a short circuit is detected.
•
If the cable is unplugged, the port returns to the detection state, and will remain off until suitable power draw is detected.
Forced
-
on mode
If forced
-
on is selected, then the port operates in this strict order:
•
There is no resistance check on the port. The switch applies power on pins 4,5 (+) and 7,8 (
-
), even if no cable is attached.
•
When power is applied, the switch continuously checks if an overload or a short circuit is detected.
•
After the cable is unplugged, the power still remains enabled on the port.
Off mode
If off mode is used, PoE
-
Out on the port will be turned off, no detection will take place, and the interface will behave as a sim-
ple Ethernet port.
PoE
-
Out limitations
It is important to check the PoE
-
Out specifications for hardware limitations because it can differ between models.
PoE
-
Out ports are limited with maximum amp values which are supported for a particular voltage. Usually max current will
differ for low voltage devices (up to 30 V), and for high voltage devices (31 to 57 V).
PoE supplying devices also have a total current limitation which can't be exceeded, even if individual port limit allows it.
All CIS equipment uses the same PoE
-
Out pin polarity
Mode B
4,5 (+) and 7,8 (
-
), however other vendors can use opposite o r
Mode A pinout on PD, this requires using a special
crossover cable
Enable/Disable PoE on a Specific Port
Select the port from the
Interfaces
tab. Change the PoE Out option accordingly.
All manuals and user guides at all-guides.com
