Page 8
Rev. 2.0
CobraNet
TM
EV-2
CNEval.exe communicates with the EV-2 via an RS-232 serial connection. CNEval.exe can communicate
using either COM1 or COM2 of the PC on which it is running. The connection from computer to EV-2
must be made as follows:
•
Connect a straight-through, male-to-female, 9-pin RS232 cable to EV-2 connector P501.
•
Select the appropriate PC serial port. The software will attempt to make contact with the EV-2.
•
Once communication is established, the routing can then be configured. (See
Figure 7
below for
an example of a routing scheme.)
The default on power up state of the EV-2 is for the ADC and DAC to be the source and sink respectively,
using the CM’s SSI #0 I/O stream. The audio is then transmitted/received via a CobraNet Bundle to/from
the other CM. This allows evaluation of the CobraNet module in the analog domain without any
configuration.
Clicking on any of the product or company logos will pull up the corresponding website using the
computer's default browser (an Internet connection is required).
The EV-2 software also has a programming mode that may be used to perform field updates of the EV-2
microcontroller code. For more information about the programming mode, please refer to the section
Programming the Microcontroller
below.
Figure 7. Screen Shot of EV-2 Software
Содержание CobraNet EV-2
Страница 29: ...Page 28 Rev 2 0 CobraNetTM EV 2 Drawings ...
Страница 46: ...CobraNetTM EV 2 Page 45 ...