Cirrus Logic CDB5378, Руководство пользователя

Страница: 34 / 75

CDB5378
34 DS639DB4
The VD and VCORE power supplies on CDB5378 include reverse-biased Schottkey diodes to ground to
protect against reverse voltages that could latch-up the CMOS components. Also included on VD and
VCORE are 100 uF bulk capacitors for bypassing and to help settle transients plus individual 0.1 uF by-
pass capacitors local to the digital power supply pins of each device.
2.5 PCB Layout
2.5.1 Layer Stack
CDB5378 layer 1 is dedicated as an analog routing layer. All critical analog signal routes are on this layer.
Some CPLD and microcontroller digital routes are also included on this layer away from the analog signal
routes.
CDB5378 layer 2 is a solid ground plane without splits or routing. A solid ground plane provides the best
return path for bypassed noise to leave the system. No separate analog ground is required since analog
signals on CDB5378 are differentially routed.
CDB5378 layer 3 is dedicated for power supply routing. Each power supply net includes at least 100 µF
bulk capacitance as a charge well for settling transient current loads.
CDB5378 layer 4 is dedicated as a digital routing layer.
2.5.2 Differential Pairs
Analog signal routes on CDB5378 are differential with ded and - traces. All source and return an-
alog signal currents are constrained to the differential pair route and do not return through the ground
plane. Differential traces are routed together with a minimal gap between them so that noise events affect
them equally and are rejected as common mode noise.
Analog signal connections into the CS3301A/02A amplifiers are 2-wire IN+ and IN- differential pairs, and
are routed as such. Analog signal connections out of the CS3301A/02A amplifiers and into the CS5373A
Figure 4. Differential Pair Routing
IN+ IN-