Cirronet SEM2411 /SEM2411 X, Руководство пользователя

Страница: 24 / 40

SEM2411
Clicking on Enable IP address control and then Apply brings up the dialog below.
Enable IP address Control
This dialog is used to designate the Allowed IP addresses from which the SEM2411 will accept a
telnet session request. Simply enter an IP address in the “Allowed IP address” field and click
“Add IP address. Only IP addresses designated by this dialog can access the device when IP
address control is Enabled.
Access Control Users
This dialog allows the modification of logins and the ability to add new users.
Note: Click on Save Settings to store the system configuration changes in non-volatile
FLASH memory. The user may either click on “Reset” to reboot the processor, click on
“Logout” to end the
browser session or simply close the browser window.
Console Port
The SEM can be configured two ways: Through a browser session once an IP address has been
obtained and through a serial session through the console port. The settings for the console port
are 38400 baud, 8 data bits, 1 stop bit, and no parity. The WinSEM program can be used to set
up the SEM through the Console port. The appropriate serial port must be selected in WinSEM,
but the program will automatically set up the serial port. After a few seconds the SEM firmware
version is displayed followed by the
SEM>
prompt.
To set the IP number of the SEM, use the ip command.
ip <xxx.xxx.xxx.xxx> {yyy.yyy.yyy.yyy}
Where x is the new IP address and y is the optional netmask number.
Once a valid IP address has been entered in the SEM, a second method to configure the SEM is
through a telnet session. Most telnet programs work with the SEM. Windows
95/98/NT/2000/ME have a telnet program that works with the SEM. A telnet session can be
started by clicking on Start->Run if you have Windows 95/98/NT/2000 and the TCP/IP client

2000- 2004 Cirronet

Inc 18 M-2411-0007 Rev B