Cirronet HopNet 10 Series, Руководство пользователя

Страница: 77 / 106

Status Commands
800281 Rev. B HopNet Family of Products 69
Status Commands
These commands deal with general interface aspects of the operation of the HopNet.
Command Description
zb[?|0|1] Banner Display Disable
0 = disabled
1 = enabled (default)
zc[?|0..2] Set Escape Sequence Mode
0 = disabled
1 = once after reset (default)
2 = unlimited times
zh?
Read factory serial number high byte.
zm?
Read factory serial number middle byte.
zl?
Read factory serial number low byte.
zp[?|0-5]
(base only)
Set the duty cycle at which the modem will wake up to send and
receive data. Duty cycle equals 1/2
N
where the argument of the
command equals N.
zq[?|0|1]
(remote only)
Low Power Acquisition Mode Enable
0 = Disabled (default)
1 = Enabled
z> Exit Modem Control Mode
Banner Display Disable
Enables or disables display of the banner string and revision code automatically at
power-up. May be disabled to avoid being mistaken for data by the host.
Set Escape Sequence Mode
Enables or disables the ability to use the in-data-stream escape sequence method of
accessing Control Mode by transmitting the string ":wit2410". When this mode is set to
1, the escape sequence only works immediately after reset (this is the default). When set
to 2, the escape sequence may be used at any time in the data stream when preceded by
a pause of 20 ms. For backwards compatibility with the WIT2400, the string ":wit2400" is
also accepted for entering Control Mode. Note that the escape sequence must be
interpreted as data by the radio until the last character is received, and as such will be
transmitted to a receiving radio station.