Circutor URBAN WB Series, Руководство по установке, Страница: 7 / 24

URBAN WB
Installation guide 7
E L E C T R I CA L W I R I N G C O N S I D E R AT I O N S
1 — C H A R G E P O I N T – I N P U T P OW E R S U P P LY
Charge point may not include elements of electrical protection.
The input power supply line must be hardwired from a distribution board to the charge
point under electrical safety regulations according to your country regulations.
2 — P OW E R S U P P LY L I N E D I M E N S I O N I N G
The dimensioning of the input power supply line of the charge point must be checked by a
qualified electrician. Note that various factors such as cable length between distribution
board and charge point, maximum output current of the charge point may have influence
of the selected cable.
In such cases, increasing the cable cross-section it is required to adapt the temperature
resistance of the power supply line.
3 — C H A R G E P O I N T – M A X I M U M C U R R E N T O U T P U T
Please refer to the TECHNICAL DATA section to consult the default factory settings from
maximum output current of the charge point.
If the power supply is less than maximum output current and adjustment to a lower
nominal current needs to be performed, please refer to the INSTRUCTION MANUAL.
Depending of the model this value may vary.
Take into consideration this section before start wiring
connections of the charge point.
Before the
installation