Circutor RGU-10 MT, Инструкция по эксплуатации

Страница: 8 / 42

8
RGU-10 MT
Instruction Manual
3.- INSTALLING THE DEVICE
3�1�- PRELIMINARY RECOMMENDATIONS
The operators using and handling the device must follow the safety measures estab-
lished in the country where the device will be used to guarantee its safe operation,
using personal protective equipment if needed.
The RGU-10 MT device must be installed by authorised and qualified staff.
Disconnect the device from the mains and disconnect the measuring devices before handling, chang-
ing the connections of or replacing the device. Handling the device while it is connected is hazardous
to people nearby.
The cables must be in perfect working order to prevent accidents or injuries to people and/or damage
to the facilities/installations.
Limit the operation of the device to measuring the specified current or voltage values.
The manufacturer of the device shall not be held responsible for any damage resulting from the user
or installation company failing to observe the warnings and/or recommendations indicated in this
manual nor for any damage resulting from the use of non-original products or accessories or those
from other brands.
Do not use the device to take measurements if you detect an anomaly or malfunction.
Check the environment in which the device is installed before taking a measurement. Do not use the
device to take measurements in dangerous, explosive, wet or damp environments.
Disconnect the device from the mains and from the power supply (both the device and
its measuring system) before performing any maintenance work, repairs or handling
any of the connections of the device.
Contact the after-sales service if you detect that the device is not working properly.