Page no.
34
2.
How to install the SIM card
8)
Undo the screws from the SIM card holder cover.
Tapa
Soporte SIM
9)
Carefully remove the part.
10)
Take out the SIM card safety holder.
11)
This safety position will allow the holder to be opened and the SIM card installed.
12)
Close the holder and replace it in its original position.
13)
Gently attach the cover for the SIM card holder on the
QNA
.
14)
Screw on the cover to avoid operating problems with the SIM card.
3.
With the new SIM card installed:
15)
Disconnect the RS-232 cable from the equipment.
16)
Wait for indication from the PC software (Approximately 60 secs.).
17)
Reconnect the RS-232 communications cable to the
QNA
.
18)
Check that the PC software de PC is showing the result of the action. If the result
is:
Satisfactory: The
QNA
modem is ready to operate.
Error: It has not been possible to start the SIM card. Check the setting again.
Very carefully follow all the steps.
After installation, check that the RS-232 cable is not connected to the PC.
If it is connected, it will prevent the QNA from communicating via the GSM modem.
The local modem must not be connected via a telephone
switchboard. It must be a direct line.
SIM card
holder cover
