Circutor CEM-C12, Инструкция по эксплуатации

Страница: 16 / 28

Press

to skip to the next programming step.
6�3�- DATA BITS
This screen shows the number of data bits. Press

> 3 seconds to open the configuration screen.
> 3s
Note:
This parameter cannot be modified.
Press

to skip to the next programming step.
6�4�- PARITY
This screen is used to configure the parity. Press

> 3 seconds to open the configuration screen.
> 3s
Press

to change options.
Press

> 6 seconds to save the change. The screen shown in
Figure 11
indicates that the changes
have been saved correctly.

Configuration values
Table 8: Configuration values: Parity�
Parity
Possible values
MOME
No parity
Odd
Odd parity
EUEM
Even parity
Press

to skip to the next programming step.
6�5�-STOP BITS
This screen is used to configure the number of stop bits. Press

> 3 seconds to open the configuration
screen.
> 3s
Press

to change options.
16
CEM-C12
Instruction Manual