Circutor AFQevo, Инструкция по эксплуатации

Страница: 26 / 102

26
AFQevo
Instruction Manual
We recommend clamping the cables to part of the frame of the cabinet, to reduce any tension
in the connection.
To access the communications ports, it is necessary to remove the cover at the back of the unit,
by loosening the Torx 30 screws. The list of terminals is shown in
Table 14
and in
Figure 17
.
The “master” device is the device placed at the top of the cabinet.
Table 14:List of terminals�
Device terminals
1:
ETHERNET , Ethernet Connector
4: A,
RS-485 communications
2: IN
,
Input for parallel connection
5: B,
RS-485 communications
3: OUT ,
Output for parallel connection
6: S,
RS-485 communications
1
2 3
4 5 6
Figure 17: AFQevo terminals part 2 (AFQe-xxx-100C and AFQe-xxx-200C)�
The connection cables should be passed through the cable grommet at the bottom of the
cabinet. We recommend separating the communications cables from the power cables, to
reduce interference.
We recommend running the cables along the side of the cabinet and clamping them to the
frame of the cabinet, to reduce disturbances in the airflow and any tension supported by the
connections (
Figure 18
).
Cables
Figure 18: Running the cables along the side of the cabinet�
When the wiring is complete, fit the cover at the back and the front covers (torque 5 Nm )