1.2 Assembly
Pic 1.
Pic 2.
Pic 3.
Step 1. Remove the Atlas from its bag and lay it on its side. This should be the side that has the the Q/R buttons for the axles
protruding from it.
Step 2. Lightly press on the lower section of the trailer, i.e. the side that is nearest the floor, this will depress the Q/R buttons
on the axles allowing you to unfold the top section of the trailer.
Step 3. You can now remove the frame parts and the wheels. Lay these to one side so that the underside of the trailer platform
is left fully exposed. Then place the cross member into the position shown in the pic 4. with the U channel at the end facing
up.
Pic 4.
Pic 5.
Pic 6.
Step 4. Lay axle in place (NOTE the axle should be orientated so that the end with the single reinforcement plate should fit in
the U of the cross member, with the re enforcement plate facing out of the U).
Step 5. Now screw the thumbwheels through the frame into the trailer platform, making sure the holes in the frame are
aligned to the holes in the trailer platform. (IMPORTANT make sure the thumbwheels are done up tightly, these should be
checked regularly)
Step 6. Install the Q/R axles in the wheels and fit the wheels to the trailer axle, making sure the wheels have secured properly
by pulling on them. If the wheels can be pulled off, then the Q/ R axles will need adjusting (see section 3.2 Adjusting Q/R
axles).
Step 7. Push the trailer hitch arm into the locating tube and fit the safety pin, orientate the safety pin in such a way that it does
not restrict turning the hitch to the correct angle for the bike to which it is to be attached (see Pic 8).
Step 8. Hitch Up! See section 1.3 Fitting hitch to bike, and adjust angle of hitch arm so that the trailer platform is roughly level
and then re tighten the Q/R to lock it in place.
Page 3
Содержание Atlas Trailer
Страница 1: ...Atlas Trailer Owners Manual ...
