CipherLab Series 8, Справочное руководство

Страница: 41 / 67

35
The table below lists the AT commands supported for establishing a connection via GSM
or 3G/GPRS separately. You can click the desired command below for more information.
AT Commands Description GSM
Mode 3G/GPRS
Mode
AT Get echo from the cradle.
√ √
ATDT Dial out to establish a data connection via GSM or
3G/GPRS.
√ √
ATF Load factory defaults.
√ √
ATW Write the current settings to flash.
√ √
AT+APN ? Get the Access Point Name (APN) currently in use.
√
AT+APN = Set the Access Point Name (APN) you want to connect
to.
√
AT+BAUD = Set Baud rate (only for 3G Cradle)
√ √
AT+CHAP ? Get the Challenge-Handshake Authentication Protocol
(CHAP) setting.
√
AT+CHAP = Set the Challenge-Handshake Authentication Protocol
(CHAP) setting, enable or disable.
√
AT+CLCK=SC , 2 Get the information about whether PIN authentication is
applied to the facility lock of SIM card.
√ √
AT+CLCK=SC ,
<Parameter>,
<PIN>
Set PIN authentication, enable or disable.
√ √
AT+CPIN ? Get the information about whether PIN or PUK code is
required.
√ √
AT+CPIN = Set PIN code for authentication.
√ √
AT+CPWD=SC Change PIN code of SIM card.
√ √
AT+DHCP ? Get the Dynamic Host Configuration Protocol (DHCP)
setting.
√
AT+DHCP = Set the Dynamic Host Configuration Protocol (DHCP)
setting, enable or disable.
√
AT+DLMT ? Get the delimiter check status, as well as the used
delimiter character.
√ √
AT+DLMT = Set the delimiter check, enable or disable.
√ √
AT+DOWNLOAD Download firmware to the cradle.
√ √
AT+ERR ? Get the last 4 digits of error code for the initialization
procedure.
√ √
AT+IP ? Get the fixed IP address of the cradle.
√
Appendix II
AT COMMANDS