Christoph F. Bruggaier, Bavariafilmplatz 7, D-82031 Grünwald, Germany
version 1.0, Oct. 2008, page 7 of 9
Operation
Switch the SRWpower LE on by operating the mains switch located right underneath the
power inlet. The blue operating LED goes on. Then switch on your appliance.
If, for some reason, the AC supply fails, the battery attached to the SRWpower LE will
substitute the AC supply for a short time. This situation is indicated by a red flashing LED on
the top main panel (bail out condition). With a full battery, you will at least be able to finish
your take. The amount of time for which the battery is able to substitute the AC supply is
limited and depends on its capacity and wear. Therefore it is advisable to attach a fully
loaded battery to the SRWpower LE before beginning to record.
Before switching off the SRWpower LE, please make sure that you have shut down your
appliance and it is switched off completely to prevent data loss and damage.
Troubleshooting
Please make sure not to overload the SRWpower LE. If, for any reason, the SRWpower LE
maximum output was exceeded, the secondary fuse on the top main panel will blow. This will
be indicated through a red LED (fuse fail.). If a secondary fuse is blown, it has to be replaced
with exactly the same type and value (5x20mm, 8A slow blow) after having cleared the
overload situation. Please switch the SRWpower LE off and remove the AC cord before
replacing a fuse.
There are no servicable parts inside the SRWpower LE. Please contact the
manufacturer/dealer in case of any malfunction. We will try to help you getting the problem
fixed as soon as possible.
Transportation and storage
The normal storage temperature of this unit lays between –25°C and +60°C, the operating
temperature is specified from –20 to +40°C.
Please allow temperature adaption before unpacking after drastic temperature changes to
prevent water condensation and to allow remaining condensed water to dry off. We
recommend to use silica gel pads to create a dry atmosphere in the transport case. Please
take into account that these pads have to be freshened up on a regular basis by drying them
according to the manufacturer’
s recommendations.
