Virtual Destination Groups
Virtual destination groups are intended to organize the incoming IP streams into logical groups.
Creating, deleting and editing virtual destination groups is similar to the physical source groups operating.
Refer to the
Physical Source Groups
paragraph for details.
The virtual destination groups will be shown as separate tabs in the Cinegy Route Control application.
Refer to the
Cinegy Route Control
section for information about Cinegy Route Control.
Virtual Destination Creation
To add a new virtual destination, choose "Virtual Destinations" or select a desired virtual group, in which you
would like to create a destination and press the "Add…" button in the main toolbar. The following "Edit virtual
source" dialog box appears:
Enter a virtual destination name here and define its visibility parameters using the "Visible To…" control.
Visibility configuration is described in the
Visibility Management
article.
To edit the name or visibility parameters of the existing virtual destination, use the "Change…" button in the
main toolbar.
To delete an existing virtual destination, select the required one and press the "Delete" button in the main
toolbar. The following dialog will appear asking you to confirm your decision:
Processing Nodes
Processing nodes are intended to create and edit sets of various video and audio streams. You can select only one video
stream from the primary video sources and up to four audio streams from the secondary audio sources. In processing nodes
it is possible to mix audio streams, edit the audio delay and signal level values. When the set of video and audio streams is
changed, all the clients will receive the updated information in a few seconds without interrupting the playback.
Page 14 | Document version: e23d164
