Esprocker Full Instruction
1. Turn On/Off Esprocker Controller
2. Synchronize Esprocker Controller and Motor
3. Automatic Lens Calibration
4. Manual Lens Calibration
Hold the (REC) button on your esprocker controller for three seconds to turn
it on. When your esprocker controller is on, hold the (REC) button for three
seconds to turn it off. The number that shows up on your esprocker controller
when you turn it on is the esprocker controller’s battery percentage.
Hold the button on your motor that flashes blue for three seconds, when the
button’s light turns green, press and hold all three buttons, (REC), (A) and (B) on
your esprocker controller for three seconds. In this way, it synchronizes both the
esprocker controller and motor together.
Hold the (REC) button for three seconds to turn the esprocker controller on/off.
Hold the button on the motor for three seconds then hold all three buttons on
the esprocker controller for three seconds.
Hold the (REC) and (A) button for three seconds.
After your esprocker controller and motor are synchronized, press and hold
(REC) and (A) button on your esprocker controller at the same time for three
seconds, this activates the automatic lens calibration. This option is for the
camera lens that has the hard stops. For the camera lens that does not have
the hard stops, read the following manual lens calibration below.
Hold the (REC) and (B) button for three seconds. Press the (A) button to rotate
the lens clockwise, then press the (A) button again to stop the rotation and press
the (REC) button to set the start point. Press the (B) button to rotate counter
clockwise and press the (B) button again to stop the rotation, then press the
(REC) button to choose the end point.
After your esprocker controller and motor are synchronized, press and hold
the (REC) and (B) button on your esprocker controller at the same time for three
seconds until S-1 flashes. Then press and hold the (A) button for three seconds
until the gear rotates. When your camera lens reaches the minimum focus
distance, press on the (A) button again which makes the gear stop rotating.
Then press the (REC) button to set your camera minimum focus distance
point. After you set the minimum focus distance point, S-2 should be flashing.
Then press and hold the (B) button for three seconds, the gear will rotate to the
opposite direction. When it reaches your camera’s maximum focus distance point,
you have to press the (B) button again to stop the rotation of the gear. Then
press the (REC) button to set the camera’s maximum focus distance. Remember,
you can always press on the (A) button or the (B) button for the micro adjustments
when it passes the camera’s focus distance.
© 2015 CINEGEARS All Rights Reserved
