Setting Up the Controller
Synchronization
Turn on the remote control power switch and plug in the motor. Once both are
on hold (SET) + (POWER) for 3 seconds. The motor light will stop blinking, and
the gear will shudder. This means that the controller and motor have been
successfully synchronized. (Note: This process is usually done before leaving
the factory.)
Automatic Calibration
1) Before installing the drive onto the lens, please make sure the wireless
remote controller and motor are powered on and connected. DO NOT turn the
wireless remote control dial, put the drive gear close to the lens ring and
tighten the screws.The controller can automatically locate the start and end points
of any lens. To calibrate your lens, hold the (SET) + (A) button on the remote
controller for 3 seconds.
Manual Calibration
Rotate the focus ring clockwise to the end; hold (SET) + (REC) + (POWER)
buttons together for 3 seconds. Rotate to the opposite end and press the three
buttons again
LED Marker Light
Press (POWER) quickly to toggle marker light ON or OFF.
Screen Brightness
To change screen brightness, press and hold (SPEED) + (A), (B), (C), or (D),
(SPEED) + (A) being the lowest brightness level, (SPEED) + (D) being the
highest brightness level.
3
Controller
The controls have been designed for ease of use: They allow for preset
memory points, where you can save up to four, as well as two lock points
that will cause the controller to vibrate as you approach them. Choose from 16
different speed levels to control the transition speed of the presets, and 4 different
damping levels from ultraresponsive to ultra smooth. The controller has an accuracy
circuit built into it to ensure the lens stop precisely where you want it to, even after
repeated use.