5
LIGHTING PROCEDURES
If the burner flame goes out while the grill is operating, always turn gas control knobs
to the `OFF` position by turning clockwise until a positive stop is felt and wait 5
minutes before attempting to re-light the grill.
Read the safety instructions in previous sections before lighting.
•
Turn both control knobs to the
`OFF`
position by turning clockwise until a positive stop is
felt. See the picture representation below.
•
Turn one LP tank gas valve completely counter-clockwise to open gas supply to one side
of the grill.
•
Light one side of the grill at a time.
•
Immediately place a lighted match through one lighting hole underneath the center of the
grill. There are two lighting holes. Make sure to place the match at right hole, nearest the
control in use.
•
If burner fails to light, turn control knob to
`OFF`
position by turning clockwise until a
positive stop is felt and wait 5 minutes for unburned gases to clear before attempting to
light grill again.
Forcing control knobs will damage valves.
