Cimo MZ1000, Руководство пользователя

Страница: 16 / 47

cimo User Guide
RealWear(shanghai) intelligent Co,.Ltd. Copyright 2021 15 realwear.com.cn
Step 3 - Ensure proper head-mounting accessories are in place.
These can include the hardhat with clips, bump cap, or baseball cap with mounting kit. See the article on mounting
accessories for instructions on how to attach the device to your chosen mounting option.
Step 4 - Putting on the cimo
Start by positioning the device on your head so that it is roughly level with ground. The head strap should be
positioned vertically, not at an angle, resting over the top part of your head.
Step 5 - Fitting the HMT- Lite
Adjust the head strap or mounted headwear so that the device is not hanging too low - it should be positioned
right along your temple area, above your ears.
Next, move the display pod into position. For the optimal experience it is recommended that the display is close to
the center line of your face, in front of and close to your eye.
Step 6 - Adjusting the fit
Ensure that the display pod is not positioned too far to the outside or too far in front of your eye.
Move the display towards the center line by pushing from the outside inward.
Then holding the boom arm with one hand and holding the back of the cimo with the other, push the display pod
inward so that it is close to, in front of and slightly below your eye.
Step 7 - Turning on the HMT- Lite
Before putting the cimo on your head, press and hold down the power button for about three seconds then release
the power button. The power button is the round silver button on the same side of the cimo as the boom arm/display.
In about ten to fifteen seconds you will hear a sound as the start-up sequence completes. The cimo is now powered
on and ready to wear. You should now be able to see the screen.
Step 8 - Fine tuning
It is best to tilt and rotate the display pod to make minor adjustments.