CIMLINE MATRIX 1500, Руководство владельца/оператора

Страница: 17 / 40

17
Adjusting Burner Nozzle, Electrode & Head Position Adjusting Burner Nozzle, Electrode & Head Position Adjusting Burner Nozzle, Electrode & Head Position Adjusting Burner Nozzle, Electrode & Head Position
Your CIMLINE 1500 Matrix is equipped with a model ADC burner. Each unit comes
with a nozzle, electrode and head position gauge. For optimum performance, the
steps below should be performed periodically. The burner must be removed from the
combustion chamber.
Step 1: Setting the Electrode Gap
Check electrodes to see if the gap is aligned with the lines on the gauge. The gap
should be
from 1/8" to 5/32" as shown below. Bend the electrodes slightly if required. If the
electrodes are way out of line, you may have to remove the head and realign as de-
scribed in Step 3.
Step 2: Inspecting Nozzle Concentricity
The nozzle should be approximately centered within the head. Insert the
gauge as shown. The center of the nozzle should be aligned with the cen-
ter line. Rotate the gauge and check alignment from several locations.
BE CAREFUL NOT TO SCRATCH THE SURFACE. If it is not concentric,
you may have to replace or straighten center bracket.