Loudspeaker
Balance
Trim Pots
Line Output
Wired Input/AUX1
Wired
Input/
AUX2
Mono / Stereo
Jumper Selector
Loudspeaker
Outputs
AC MAINS
Input
Rear Panel Controls and Connectivity:
Screw terminal connections for AC Power, AUX Wired Inputs, Loudspeaker Outputs and Line Level outputs
are located on the rear PCB of the AVID3ACBT.
The AVID3ACBT is powered via a fused 230v AC outlet.
The two wired AUX input terminals on the rear are configured for a Stereo Input Signal; the three-way
connector has terminals for L (Left Signal), G (Screen) and R (Right Signal).
Important Information:
It is important to note that if using the audio input located on the rear of the AVID3ACBT that the signal
applied is at full line level.
When using this application an appropriate screened cable is required to reduce the possibility of external
signal interference.
Note.
The wired input Aux 1 terminal is in parallel with the 3.5mm Jack Input on the front panel; if either
inputs are connected and a signal is present on both, then the two sources will be mixed together (This
should be clearly explained to the user).
The wired input AUX2 terminal is in parallel with the Bluetooth receiver. If either inputs are connected or
in use then the two sources will be mixed together.
A jumper is provided to allow the AVID3ACBT to be used in either mono or stereo mode, the factory default
is stereo. If set to mono the amplifier will provide a mixed output to each loudspeaker terminal.
Loudspeakers should be wired to the L+ L- and R+ R- terminals, ensuring the phase of each loudspeaker
is the same.
The line output is stereo and provides a fixed line output signal for feeding and external source such a s a
slave amplifier or induction loop system.
If you are experiencing any problems please contact your reseller or the CIE-Group Technical Support
Department on +44 (0)115 9770075.
Introduction:
Before installation please remove the Facia Trim Plate from around the front edge of the unit. This can be
refitted once the installation is finished and any decorating is completed. Please note: The pair code for
Bluietooth connectivity is located behind this trim plate.
The compact depth of the AVID3ACBT unit will allow installation into standard UK 2-gang EO boxes, with a
minimum of 40mm depth. A plastic EO box is now included for recessed installation.
These may be galvanised metal for installation in solid construction walls, plastic drylining (with lugs) or
may be installed into surface mounting Dado-type trunking systems using the appropriate fixings.
Front Panel Controls and Connectivity:
3 illuminated buttons allow basic control of the AVID3, the bottom button ( ) controls the ON/OFF
function, the up/down buttons ( ) control Volume Up and Volume Down.
A stereo 3.5mm Jack input is provided on the front panel, two further hard wired inputs are provided to
the rear of the AVID3ACBT plus a Bluetooth receiver.
The Hi/Lo switch adjusts the input sensitivity from 1v (Line Level) to 200mv (average Headphone output
level), allowing the interface of generic MP3, CD and media players without loss of system volume level.
A clear LCD Display shows the desired volume level between 0 (no output) to 20 (maximum output) as well
as showing which input is in use (S1/S2).
Fascia
Trim
Plate
Hi/Lo Line
Level
Sensitivity
Switch
IR
Receiver
Window
Audio Level
& Input
selection
Display
Volume
Level
Up
Volume
Level
Down
ON/OFF
Switch/
Input Select
3.5mm
Jack
Input
Bluetooth
active LED