CID SBC 14-20 GPM, Руководство пользователя

Страница: 28 / 58

Swing Boom Cutter
August 2021
28
4.2 Maintenance Schedule
This brush cutter attachment will provide years of dependable service if routine
maintenance procedures are performed. The maintenance tasks listed below are
based on normal operating conditions. More frequent maintenance may be necessary
with intense use or when operating in adverse environmental conditions.
MAINTENANCE TASK
BEFORE
EACH
USE
WEEKLY YEARLY
Check skid steer loader hydraulic fluid level. Add
fluid as necessary.
Check that all fasteners (nuts, bolts,, washers, pins,
keepers) are in place. Tighten as necessary. (See
Bolt Torque Table on page 37)
Inspect and replace any worn, torn, or missing
safety decals.
Inspect hydraulic plumbing (hoses and
connectors) for damage or leakage. Repair or
replace hydraulic items as necessary.
Check condition of cutter blades. Sharpen or
replace as necessary.
Check oil level in bearing housing. Add fluid as
necessary.
Change oil in bearing housing.
* Change oil after
50 hours of first time use, then every 1000 hrs or
yearly.
Wash Brush Cutter
• x
Check brush cutter for major scratches and
dings.Sand and repaint these areas to prevent
rust damage. *Use a paint formulated for farm
equipment which can be found at your local
hardware store .
Lubricate all pivot joints.
• x
X
X
X
X
X X X
X
X
X
X
Maintenance Log
Document all maintenance and service activities performed on this brush cutter using
the maintenance log included at the end of this manual.
X