CIAT Divio Series, Установка, Эксплуатация, Пусконаладка, Обслуживание

Страница: 4 / 8

EN - 2
1. GENERAL
1.1 General information
This manual is dedicated exclusively for the qualified, authorised installation technician who must be adequately trained and
possess all the necessary psychophysical requirements requested by law.
All the operations must be performed with care and good workmanship in compliance with the safety at work regulations
in force.
•
After unpacking, make sure that all the components are present. If there are any missing itmes or the unit does not conform,
indicate the reserves on the delivery slip and confirm them by registered letter to the transporter within three working days.
• It is forbidden to modify the safety or adjustment devices or adjust without authorisation and indications of the manufacturer.
• It is forbidden to dispose of, or leave in the reach of children, the packaging materials which could become a source of
danger.
•
All repair or maintenance interventions must be performed by professionally qualified as foreseen in this booklet. Do not
modify or intervene on the appliance as this could create dangerous situations and the manufacturer will not be responsible for
any damage caused
.
1.1.1 Compliance
The CIAT Divio comfort units conform to European directives LVD, EMC, RoHS e RAEE: 2006/95/EC, 2004/108/EC, 2002/95/
EC and 2002/96/EC
1.2
Symbols
The pictograms in the next chapter provide the necessary information for correct, safe use of the machine in a rapid,
unmistakable way.
Index
- Paragraphs marked with this symbol contain very important information and recommendations, particularly as regards safety.
Failure to comply with them may result in:
- danger of injury to the operators
- loss of the warranty
- refusal of liability by the manufacturer.
Generic danger
- Signals to the personnel that the operation described could cause physical injury if not performed according to the
safety rules.
Electrical hazard
- If the operation is not carried out in compliance with the safety regulations there is a risk of suffering physical injury
due to contact with components under tension.
1.3 Electrical characteristics table (fig. 1)
Divio 700 900
Power supply
230V/1ph/50Hz +/- 10%
Power supply cable minimum section
1,5 mm
2
Min and max operating temperature limits
0°C / 50°C
Min and max operating relative humidity
15% / 85°C
imput current
0.1 A
Fig. 1