page 6
Precautions for use
Storage and usage conditions
General
Disclaimer
Warning
The device is not suitable for use by children or disabled persons unless appropriately supervised by a
responsible adult able to use the device itself in complete safety. Children must not be allowed to play with the
device.
C.I.A.R. will not be held liable for its product if its use does not comply with the following requirements:
-
The working cycle when used with Ciar actuators is 2 minutes work with 5 minutes pause.
-
Only C.I.A.R. authorised personnel can dismantle the various parts of the kit.
-
Do not cut or touch any wires in the kit with sharp objects.
-
Do not connect the kit other than in the manner described in this manual.
-
Do not use any parts of the kit with devices other than those indicated in this manual.
-
Do not connect the power supply cable to a mains supply of voltage different to that indicated in
this manual and on the labels attached to the device.
-
Do not wet the parts making up the kit.
-
Do not place any metal objects near any parts of the kit while it is plugged into the mains.
-
Do not use the device other than in a domestic environment.
-
Do not open the device for any reason. Any faulty or broken parts must be returned to the
manufacturer or an authorised service centre or placed in the hands of
a person possessing similar qualifications, avoiding all possible risks.
-
Do not use in damp environments or in the presence of heat sources (ovens or direct sunlight).
- In the case where the power cable is not detachable from the device and has been
damaged, it can be replaced by the manufacturer, an authorised service centre or
a person possessing similar qualifications, avoiding all possible risks.
STORAGE AND USAGE CONDITIONS
Working environment:
Temperature:
between 0°C and 45°C
Humidity:
between 20 and 70% (without condensation)
Storage environment:
Temperature:
between -20°C and +45°C
Humidity:
between 10 and 70% (without condensation)
- If the device is to be left unused for a long period of time, the batteries will slowly self-discharge and
the resulting over-discharge may damage the batteries themselves. It is advisable to fully charge the batteries
at least once every 3 months.
- If a new battery is not used for approximately one month after the last recharge, the remaining charge is
approximately half the nominal charge.
The constructor of the finished product in which the motor kit and eventual battery kit will be installed must
compile an instruction manual for the use of his own product.
The content and safety notes of this manual can be freely used for the final product.
Please keep the PS10BSA disconnected from load and / or control devices during storage or transportation to
avoid undesired action or discharge.