Chung Nam Electronics WLC300GA, Руководство пользователя

Страница: 18 / 21

Guide to OEM integrators
This device is intended only for OEM integrators under the following conditions:
(1) The antenna must be installed such that 20 cm is maintained between the antenna and users;
(2) The transmitter module may not be co-located with any other transmitter or antenna;
(3) For all products market in US, OEM has to limit the operation channels in CH1 to CH11 for
2.4G band. OEM shall not supply any tool or info to the end-user regarding to Regulatory Domain
change. As long as 3 conditions above are met, further transmitter test will not be required.
However, the OEM integrator is still responsible for testing their end-product (host of this device)
for any additional compliance requirements required.
IMPORTANT NOTE : In the event that these conditions can not be met (for example certain
laptop configurations or co-location with another transmitter), then the FCC authorization is no
longer considered valid and the FCC ID can not be used on the final product. In these
circumstances, the OEM integrator will be responsible for re-evaluating the end product
(including the transmitter) and obtaining a separate FCC authorization.
End Product Labeling
This transmitter module is authorized only for use in device where the integrated antenna may be
installed such that 20 cm may be maintained between the antenna and users. The final end product
must be labeled in a visible area with the following: “Contains FCC ID: Q72WLC300GA”.
Manual Information To the End User
The OEM integrator has to be aware not to provide information to the end user regarding how to
install or remove this RF module in the user’s manual of the end product which integrates this
module. The end user manual shall include all required regulatory information/warning as show in
this manual.
17