front must face your child. Run sensor cord underneath the shirt.
Fasten the alarm unit to the
outside neckline or around
arm with optional armband
accessory (sold separately).
Attach the sensor to the
outside of your child’s
undergarment. Ensure that
sensor front (black face)
touches the undergarment.
Tape the sensor back (white
face) with Flexitape (includ-
ed).
Optionally, tape the sensor
and place between two pairs
of undergarments. Sensor
I
NSTALLING
A
LARM
U
NIT
&
S
ENSOR
♦ Sound and vibrate mode: Press and release the program switch
till the alarm unit beeps and vibrates simultaneously. Both
sound (gren) and vibrate (amber) icons will flash.
♦ Sound mode: To enable sound and turn off vibration, press and
release the program switch till the alarm unit beeps and
vibration turns off. Only the sound (green) icon will flash.
♦ Discreet mode: To enable vibration and turn off sound, press
and release the program switch till the alarm unit vibrates and
sound turns off. Only the vibrate (amber) icon will flash.
The alarm tone last played will be selected and the unit will
enter standby (power save) mode 10 seconds after the last
adjustment is made with the program switch.
You can select among 3 alarm
configurations: sound and vibra-
tion, sound only and vibrate
only. To select the alarm configu-
ration, disconnect the sensor
from the alarm unit by removing
the sensor plug from the sensor
jack and follow the steps below.
S
ETTING
T
ONES
&
V
IBRATION
To extend battery life, disconnect sensor from the
alarm unit when not in use.
If the red LED on the alarm unit glows, the batteries
are weak. Replace the batteries promptly.
Tones are changed by the alarm unit each time the
sensor is disconnected and reconnected.
After each use, rinse both surfaces of the sensor with
warm tap water and gently pat dry. Do not use soap.
Remove the snap-on clip from the back of the alarm unit by
pressing upwards from the bottom of the clip or by releasing the
alarm unit from the sides of the clip. Open the battery compart-
ment door by sliding it towards the bottom of the alarm unit.
Install 2 AAA batteries (included). The alarm unit turns on. The
sound and vibrate icons light up and unit beeps and vibrates for
1 second. Gently slide the battery compartment door toward the
top of the alarm unit to close. Reinstall the snap-on clip.
I
NSTALLING
B
ATTERIES
A - Snap-On Clip B - Sensor Jack C- Battery Door
D - Program Switch E - Smart LED’s
D
B
C
E
A
K
NOW
Y
OUR
C
HUMMIE
D
ETAILED
I
NSTRUCTIONS
F
OR
U
SE
8
7
6
5
4
3
2
1
Q
UICK
S
TART
G
UIDE