Chrysler Sebring 2008, Руководство пользователя, Страница: 148 / 494

WARNING!
Vehicle exhaust contains carbon monoxide, a danger-
ous gas. Do not run your vehicle in the garage while
training the transceiver. Exhaust gas can cause seri-
ous injury or death.
Programming HomeLink
姞
Before You Begin
If you have not trained any of the HomeLink
威
buttons,
erase all channels before you begin training.
To do this, press and hold the two outside buttons for 20
seconds until the red indicator flashes.
It is recommended that a new battery be placed in the
hand-held transmitter of the device being programmed
to HomeLink
威
for more efficient training and accurate
transmission of the radio-frequency signal.
Your vehicle should be parked outside of the garage
when programming.
1. Turn the ignition switch to the ON/RUN position.
2. Hold the battery side of the hand-held transmitter
away from the HomeLink
威
button you wish to program.
Place the hand-held transmitter 1–3 in (3-8 cm) away
from the HomeLink
威
button you wish to program while
keeping the indicator light in view.
3. Simultaneously press and hold both the chosen
HomeLink
威
button and the hand-held transmitter button
until the HomeLink
威
indicator changes from a slow to a
rapidly blinking light, then release both the HomeLink
威
and hand-held transmitter buttons.
Watch for the HomeLink
威
indicator to change flash rates.
When it changes, it is programmed. It may take up to 30
seconds, or longer in rare cases. The garage door may
open and close while you train.
146 UNDERSTANDING THE FEATURES OF YOUR VEHICLE