Chrysler Concorde 1993, Руководство по обслуживанию, Страница: 576 / 820

(3) Unclip power steering return hose from routing
clip on frame rail (Fig. 6).
(4) Position drain pan under remote power steering
fluid reservoir. Remove hose clamp from power steer-
ing return hose at remote power steering fluid reser-
voir (Fig. 6). Let power steering fluid drain from
remote reservoir.
(5) Remove power steering return hose assembly
from vehicle.
INSTALL
(1) Using a lint free towel, wipe clean the open
power steering hose ends, power steering fluid reser-
voir and steering gear ports.
(2) Install new O-ring and/or washer seal on the
end of the power steering return hose to steering
gear fitting. Lubricate O-rings or washer seals using
fresh clean power steering fluid.
(3) Install the power steering return hose assembly
back into the vehicle. Be sure hose assembly is prop-
erly routed (Fig. 6).
(4) Install power steering return hose into steering
gear return port and loosely install fitting. Do not
tighten power steering return hose to steering
gear fitting at this time.
(5) Install power steering return hose, onto remote
power steering fluid reservoir (Fig. 6). Install hose
clamp on power steering return hose, at power steering
fluid reservoir (Fig. 6). Be sure hose clamp is in-
stalled on hose past upset bead on power steer-
ing fluid reservoir.
(6) Route power steering return hose so it is not in
contact with any engine or body components (Fig. 6).
Then torque power steering return hose to steering
gear fitting to 31 N
I
m (23 ft. lbs.).
(7) Lower vehicle.
CAUTION: Do not use automatic transmission fluid in
power steering system. Only use Mopar
T
, Power
Steering Fluid, or equivalent.
(8) Fill the remote power steering fluid reservoir to
the proper fluid level.
(9) Start engine and turn steering wheel several
times from stop to stop to bleed air from fluid in
system. Stop engine, check fluid level, and inspect
system for leaks. See Checking Fluid Level.
(10) If required, again fill the remote power steering
pump fluid reservoir to the correct fluid level.
POWER STEERING PUMP REMOVAL
WARNING: POWER STEERING OIL, ENGINE COMPO-
NENTS AND THE EXHAUST SYSTEM MAY BE EX-
TREMELY HOT IF ENGINE HAS BEEN RUNNING. DO
NOT START ENGINE WITH ANY LOOSE OR DISCON-
NECTED HOSES OR DRIVE BELTS. DO NOT ALLOW
HOSES TO TOUCH HOT EXHAUST MANIFOLD OR
CATALYST.
REMOVE (ALL ENGINES)
(1) Remove the battery cable from the battery nega-
tive terminal and isolate cable.
(2) Loosen power steering pump serpentine drive
belt on 3.3-ltr engine, by loosening generator mounting
bolt A and adjusting bolt locknut B (Fig. 1). Then loosen
adjusting bolt (Fig. 1). Loosen power steering pump
serpentine drive belt on 3.5-ltr engine, by loosening
adjustment pulley locking nut (Fig. 2) and then loos-
ening adjusting bolt (Fig. 2).
(3) Raise vehicle on jackstands or centered on a
frame contact type hoist. See Hoisting in the Lubrica-
tion and Maintenance section of this manual, for the
required lifting procedure to be used for this vehicle.
(4) Remove the serpentine drive belt from the power
steering pump pulley, and store out of the way.
Fig. 5 Power Steering Return Hose At Steering Gear
Fig. 6 Power Steering Return Hose Routing And
Attaching
STEERING 19 - 11