Reverse Wheel
off
Reverse Slider
Save & Exit
Cancel
off
Set Radio
Chan.:
8
Freq. :
Spectrum
2422.75
Link to:
Assigned function (Focus / or Iris)
Direction :
Reverse motor direction
Torque:
Reduce torque of the motor to mid
(50%) or low (25%).
Lens Type:
Cine = end stops will be
calibrated automatically; Photo = end stops
are calibrated manually.
Mode:
Switch to dimmer mode here.
Dimmer cable can be controlled.
Play:
Modify play (backlash) compensation
for heavily used motors with a large amount
of play in the gearbox.
Safety:
Modify the safety distance, the
motor stays away from the mechanical Lens
End Stops (S3D Rigs).
Range:
Switch to 3D Rig mode if required
1/2
0
Safety
M1 Set Up
motor
Mode
Lens
0
Range
Play
2/2
M1 Set Up
Link to
F
norm
Full
Save & Exit
Cancel
Direction
Torque
Photo
Lens Type
Motor 1-4:
Enter configuration menu of
the two on-board motor channels (1-2)
and the 2 optional extended motor
channels (3-4) (MN-200R only)
Servo Lens Setup(MN-200R only)*:
Select the configuration fields for F/I/Z
with up/down buttons and adjust each
entry to "on" or "off" with left/right"
buttons. If "on" Magnum
takes over control of the desired internal servo motor.
"Z" is switched off by default but can be activated as well. If so, a
connected zoom demand controller on the 12pin Hirose socket of the
MagNum motor controller controls the zoom servo motor of the servo
lens. If "I" is switched to "off" the camera can control the iris through the
camera lens port if applicable.
*Setting is stored in the motor box in the non-volatile memory and is
editable on hand unit ID 2 as well
Motor Setup
Motor 2 (I/Z)
Servo Lens Setup
F:
Motor 1 (F)
I:
Z:
<
Back
on
on
off
Motor 3
Motor 4
*Setting is stored in the motor box in the non-volatile memory and is
editable on hand unit ID 2 as well
Cal. Mot1(F)
Motor Calibration
< BACK
Cal. Mot2(I)
Cal. Mot3(I)
Cal. Mot4(F)
10/ 6"
*Display can be disabled/enabled
on menu entry "Display Options"
Calibrate Motors
Record Trigger
Scales
10
1
sw sw
Reader ft /in
M M
sw sw
Brain. Pow.: 13.5V
Setup
2/2
Setup Hand Unit
Motor Setup
Load Defaults
Calibrate Motors
Setup
English
Record Trigger
Scales
Radio Channel
1/2
Motor Booster
Assign U Keys
Zoom Function on
select whether hand unit with ID 1 or 2
can trigger the record signal
select mode entry and modify trigger
mode with -/+ buttons
*setting is stored in the motor box in the
non volatile memory and is editable on
hand unit ID 2 as well
Record Trigger
Enabled ID:
Matching :
1
Start
Stop
Mode: < Pulse >
Save&Exit
Cancel
*Setting is stored in the Hand Unit and is
independent from Setting in HU 2.
Display Options
Ctrl. ID < >
1
Serial Socket
Enable features
Set Up Hand Unit
Left-Handed
< Back
Load Defaults
no
Wheel/Slider Cal.
