Chronos Manufactures Chrono Diamond Argos 11200, Инструкция по эксплуатации / Международная гарантия

Страница: 11 / 94

11
Argos | Instruction Manual EN
Model: 11200 Argos
Movement: Swiss made Quarz
ATTENTION: Do not set the date between 9.00 pm and 1.00 am as the date
might not change automatically the following day.
Time setting
Pull the crown carefully to position 1 and set the time by turning it clockwi se. Once
finished push the crown carefully back in to place.
Date, day and month setting
Push the button C to set the date gradually. Push the button D to set the day of the
week gradually. Push the button E to set the month gradually.
Using the chronograph
Basic function
Use the button A in order to start and stop the chronograph. The chronograph coun-
ter next to 10 for the minutes and the one for the tenths of a second next to 6 show the time measurement. Use the button B
to reset the seconds counter, the minutes counter and the tenths of a second counter of the chronograph.
Added up time measurement
Use the button A in order to start and stop the chronograph. Use the button A again in order to continue to count the time
and to stop it anew. The adding up of the time can be pursued in this way. Use the button B to reset the seconds counter, the
minutes counter and the tenths of a second counter of the chronograph.
Split time measurement
Use the button A in order to start the chronograph. Use the button B in order to show the split time (the time measurement
continues to run in the background). Use the button B in order to catch up the time (the 3 chronograph hands will be upda-
ted in fast mode onto the measured time which went on running). Use the button A in order to stop the chronograph and to
show the end time.
Setting the chronograph hands
To ensure that all chronograph hands are adjusted to the 0 position, a full initialisation must be performed after the hands
have been set. Each counter must be set once. To do this, pull the crown out to position 1. All chronograph hands will set
themselves into either the correct or the incorrect zero position. Please press button A and B at the same time, for at least 2
seconds. The second counter hand will rotate through 360° and the correction mode has been activated.
Start by pressing button A to set the chronograph second counter to 0. To switch to the 1/10th chronograph second counter
(totalizer at 6H), press button B once. Press button A until this chronograph counter has been aligned. To switch to the
chronograph minute counter (totalizer at 9H), press button B once. Press button A until this chronograph counter has been
aligned. To complete the alignment of the chronograph counters, return the crown back to the starting position of 0.