www.ChronoRemoteControl.com
- Warning: If you hold the record button (MEMO REC, ENR, PROG ...) for more
than 5 seconds, you may erase all remote controls already registered in the remote
receiver!
How to register your new remote control:
1- Open the box of your radio receiver (located at the end of the antenna wire)
2- Briefly press the record button on the radio receiver board. Depending on the
model, it can be called: ENR, PROG, MEMO or REC…
Note: According to the receivers, there are two methods:
a) you have to press and release the record button, or
b) you have to press and hold the record button
3- On the radio board, a diode should now light up or flash.
4- Press the button on your new remote control for one to two seconds.
5- Release the button. Depending on the model, the indicator on the radio board may
shut down immediately or shut down within 10 seconds after the recording is done.
6- You can now verify the proper functioning of your remote control.
7- You can now close the radio receiver.