Space Force
TM
octo LumenRadio Card QSG V2.0
QSG P/N: 650-0902
6.
Remove the jumper from the PCB
addressing card inside of the assembly. This
will not be required after you install the
wireless card.
7.
Remove the 2 x M3 screws from the PCB addressing card. These will not be required after
you install the wireless card.
8.
Included in the kit are two #4 Nylon 5/16” spacers. They
must be positioned as shown in the photograph.
9.
Install the wireless card on top of these spacers and
into the jumper port as shown in the diagram. Use a #1
Phillips screwdriver to install the 2 - M3x20 screws
included in the kit to secure the wireless card. If using a
power driver, set torque to 5.5lb-in.
10.
Insert the grommet attached to the antenna into the
holes on the engine. Ensure that the antenna does not
come out of grommet.
11.
Reassemble the unit in the reverse order. Please remember
- Do not over-torque the screws. If possible, use the recommended torques in this guide.
- Reassemble the ground to the PCB bracket assembly using the M3 star washer.
- When re-assembling the back cover, be sure to carefully plug the overlay 5 pin connector
back into the addressing card. Ensure all 5 pins are connected and carefully adjust the
harness so it does not interfere with the display or closing of the unit.
- Be sure the placement of the back cover is even before replacing the screws. Check all
corners before proceeding.
- Test for operation of unit prior to returning to service.
5. Further Information
Please refer to the Chroma-Q
®
Space Force
TM
manual for more detailed information. A copy of
the manual can be found at the Chroma-Q
®
website
– www.chroma-q.com/support/downloads
Spacer
Spacer
M3X20 Screw
Grommet
