Install all rows starting with the far left display panel.
7. After the mounts are installed, remove the white pin and tag from the top of each mount.
Installing the mount to wall studs or plywood
Learn how to install the wall mounts onto plywood.
The hardware provided is for attaching the mount through standard thickness drywall into plywood.
When installing the wall mounts on a wood stud wall covered with plywood, verify that the wood studs
are a minimum of 2" x 4" nominal size and the plywood is a minimum Grade BC 1/2" (13 mm)
thickness. Plywood may be covered by drywall up to 5/8" thick.
In areas where the mounting screws do not encounter a wood stud, the screws must be mounted onto
plywood.
1. When installing on wall studs, use an “edge-to-edge” stud finder to locate the edges of the
stud and draw a vertical line down the stud center.
Depending on the size of the display panels and the location of the mounts for the array, the
mount may not be centered on a wall stud.
2. Place the wall mount assembly on the wall to use as a template, and mark the center notch.
3. Drill a 5/32" (4 mm) diameter hole 2.5" (64 mm) deep and install a #14 x 2.5" wood screw,
leaving a 6mm (1/4") gap from the plywood.
4. Hang the wall mount on the center screw.
5. Level the wall mount and mark the center of the other four mounting holes (A).
6. Drill four 5/32" (4 mm) diameter holes 2.5" (64 mm) deep.
7. Tighten the four #14 x 2.5" wood screws so that the wall plate is firmly attached, but do not
over-tighten.
Never tighten in excess of 80 in-lbs (9Nm).
Installing flat panels on the MPL15 wall mount
Installing Flat Panels on the MPL15 Wall Mount Instruction Sheet
5
020-102543-04 Rev. 1 (08-2018)
Copyright
©
2018 Christie Digital Systems USA, Inc. All rights reserved.
