Christie D4K40-RGB, Инструкция по установке и настройке

Страница: 37 / 54

rotation and then the right knob a quarter rotation, and so on. Adjusting a single knob for
vertical or rotational adjustment to an extreme before adjusting the second knob may result in
the convergence mechanism binding.
For the best stability, Christie recommends setting convergence while rotating the knobs in a
clockwise direction. This may require first adjusting convergence by turning the knobs counter-
clockwise, and finalizing the convergence with a clockwise approach. This applies to all knobs.
6. When complete, push in all the convergence adjustment knobs to disengage them.
Aligning the image with lens zoom and focus
Ensure the image reflected from the digital micromirror device (DMD) is parallel and centered with the
lens and screen.
1. Display an image or test pattern that can be used to analyze image focus and geometry.
2. Select ZOOM.
3. Use the up and down arrows to zoom in or out of the image.
4. To exit, select Back.
5. Select FOCUS.
6. Use the up and down arrows to adjust the focus of the image.
7. To exit, select Back.
8. To refine your adjusts, repeat steps 2 to 7.
Running Auto Setup to optimize display settings
Auto Setup initiates an automated process in which the projector optimizes video settings for the
active signal. Auto Setup helps to save time in perfecting a display and you can modify the
adjustments as required.
1. Make sure of the following before running Auto Setup:
• Test patterns are turned off (on page 29).
• The active signal is valid.
2. From the remote, select Auto Signal or from the web UI, select Auto Setup.
3. Select Run Auto Setup.
The system optimizes the active signal and displays a progress message on screen.
Configuring 4K40-RGB to work with Christie Link
Configure 4K40-RGB to work with Christie Link, which provides a fully integrated fiber solution for long
range video transport.
1. Turn on 4K40-RGB.
2. Verify the HBMIC has been installed in slot 0.
3. To enable the Christie Link option, select MENU > Configuration > Input Settings >
Enable Christie Link (Slot 0).
This option is disabled if an HBMIC is not installed.
4. Select Enter.
Installation and setup
4K40-RGB Installation and Setup Guide–D4K40-RGB, Roadie 4K40-RGB 37
020-102961-03 Rev. 1 (08-2019)
Copyright
©
2019 Christie Digital Systems USA, Inc. All rights reserved.