3. Align the lens interface plate with the lens mount and align the lens electrical connector with
the mating connector on the lens mount.
4. Fully insert the assembly straight into the lens mount opening without turning and press with
your hand as shown.
5. To lock the lens assembly in place, while holding the lens flat against the lens mount, push the
lens clamp down.
6. Remove the front lens cap.
7. For added stability and safety such as motion applications, or if the projector is hoisted or
installed in an overhead position, use a 5mm hex driver to fasten the security screws provided
with the lens mount or hand tighten the lens retaining screws attached to the lens.
Christie recommends doing this for all lenses.
Ultra short throw lens installation and setup
Ultra Short Throw Lens Instruction Sheet
2
020-103300-01 Rev. 1 (12-2019)
Copyright
©
2019 Christie Digital Systems USA, Inc. All rights reserved.