ASSEMBLY INSTRUCTIONS
Page 4
5. Your shelter should be standing up completely
(Photo 9).
Anchor the shelter to the ice by using the provided ice
anchors and rope.
Screw two or more ice anchors into the ice several feet away from
the shelter using Clam’s Ice Anchor Installation Tool PN 8348 (not
included). Use the provided ropes to tie the hub eyelets to an
anchor, and the adjustment slides on the rope to achieve proper
tension.
Next, screw two anchors through the windward corner
shelter grommets completely. This will help keep the shelter in
place. If more anchors are needed, order PN 102457.
Photo 9
TAKE-DOWN
INSTRUCTIONS
TAKE-DOWN INSTRUCTIONS
1. Close all windows. Leave door open to allow air to escape.
2. Remove all ropes and ice anchors and store them in the provided
pouch. In windy conditions, remove ice anchors after collapsing the
roof and walls.
3. Step on the skirt of the short (6 foot) side. Push the center hub
until the wall collapses inward
(Photo 13)
.
Continue either clockwise
or counter-clockwise pushing each wall inward until all the walls are
collapsed
(Photo 14)
. The shelter will fall to the ice on its own.
4. Push the hub of the roof inward until it collapses
(Photo 15)
.
NOTE: Make sure the roof collapses all the way. You may have to
pull up on the edge of the roof to get the roof hub to collapse.
5. Grab one of the collapsed corners and lift up to start folding up
the shelter
(Photo 16)
.
NOTE: It is extremely important to ensure the hub systems and
poles are not tangled before completely folding the tent up for
storage (Photo 17).
6. Once the hub systems are all free and the tent is completely
folded up store in carry bag. Place the folded shelter and the ice
anchor/rope pouch back into the carrying case with the hubs
toward the bottom end of the bag.
Photo 15
Photo 13
Photo 14
Photo 16
Photo 17
Tangled
Untangled
Instruction Part # 102961
