Mounting and Installation of Inlet Components
Turbo-House Air Inlet
8
MV2308A
Ramp Hangers
When installing Ramp Hangers start at the end towards the Inlet Power Unit. The Ramp Hangers are
attached in pairs. Attach the 1st Ramp Hanger 6 inches [152mm] from the end of the Mounting Boards
with #10 x 1" Wood Screws.
Use four Screws per Hanger in the top two holes
as shown
. Slide the Ramp
Hangers up the Mounting Boards until the Tabs bottom out as
shown
. Attach the second Ramp Hanger
21-1/4" (for 6" Inlet) 28-1/8" [71 cm] (for 9" Inlet) behind the first. Attach the 2nd set of Hangers 96"
[2.43 m] on center from the previous set of Hangers
(See Figure)
. Continue attaching Hangers pairs to
the end of the Mounting Boards 96" [2.43m] on center.
(6" and 9" Inlet) 96" [2.43 m] Typical
Looking from end of Framed Opening
#10 x 1" Wood Screws
(Use Top two Holes)
(9" Inlet) 28-1/8" [71.4 cm]
(6" Inlet) 21-1/4" [540 mm]
6" [152 mm]
(Plastic Seal not shown for clarity)
4 per Hanger Typical
Hanger Tab
Mounting Boards
Ramp Hanger
