Installing the Suspension System
LIBERTY® Feeding System with Electronic Sensor (ES)
14
6.After securing the Ceiling Hook to the truss,
slide the hook of a Swivel Pulley into the slot, as
shown in
.
Drop Installation
Refer to
on page 11.
1.Attach a 3004 Pulley to each hook.
2.Thread the end of the 3/32" or 1/8" cable through the pulley toward the winch. Clamp this end to the
3/16" winch cable about 6"
[150 mm]
from the last pulley, using a 3/16" cable clamp. See
applicable figure;
3.Allow enough cable length for installation of
the Adjustment Leveler.
Sufficient cable is included to provide
"throwbacks" on drops located beneath and near
the winch.
arrangement
4.Begin installing suspension drops at the
winch and proceed to the end of the feeder
line. Keep the main cable tight between drops.
It may be necessary to hang a weight on the end of the cable to maintain tension on the line.
Support Cords and Feed Cone
With the large end of the Feed Cone up, slide the straight end of the Support Cord in the openings on each side of
the Feed Cone. The BEAD OF THE CORD must lock under the lip of the cone.
1523-84 4/2002
Wood Truss
Ceiling Bracket
1/4" Lag Screw
Swivel Pulley
3/32" Drop Cable
Figure 17.Pulley Installation
967-4 2/01
Figure 18.“Throwback” cable arrangement
Figure 19. Assembling lift Cords to Feed Cone
CORD
Turkey Feeder
Broiler Feeder