Installing the End Control and Boot Assembly
25
Installing the End Control and Boot Assembly
The End Control Unit must be at least 10 feet
[3 m]
from the end of the building to allow birds access around the
end of the feeder line.
1.Assemble the End Control Unit to the Feeder Line Control Tube using a clamp/anti-roost bracket. See
DO NOT INSTALL THE POWER UNIT AT THIS TIME.
2.Install the Feeder Boot by sliding the straight end of the Feeder Boot into the belled end of the Feeder Tube.
Install a clamp/anti-roost bracket on the bell and tighten. The Feeder Boot must be level with the open top of
the Feeder Boot flat.
3.
DO NOT INSTALL THE ANCHOR BEARING AND BEARING RETAINER AT THIS TIME
.
Figure 29.Connecting End Control Unit to the Feed Line Tube
Item
Description
Part No.
1
Control Tube
--
2
Tube Clamp
14979
3
Anti-Roost Bracket
24060
4
End Control Unit
--
1
3
2
4
Figure 30.Installing the Feeder Boot
Bearing Retainer
Anchor Bearing
Feeder Boot
Feeder Tube Bell End
