Chord Electronics
ULTIMA 2 |
Manual
_
Chord Electronics
ULTIMA 2 |
Manual
_
8 // 30
9 // 30
1.1
Introduction
1.2 Protection against
liquids & heat
1.1
Introduction
1.2 Protection against
liquids & heat
1.3 Dismantling & radio frequency
interference
1.4 Connecting your equipment
1.3 Dismantling & radio frequency
interference
1.4 Connecting your equipment
Introduction
Protection against
liquids & heat
1.1
1.2
ULTIMA 2 is part of our
Reference monoblock
amplification range.
Before operation, we strongly advise
that you read this user manual
thoroughly, storing it in a safe place
along with your original receipt of
purchase, in case you should require
assistance in the future.
The ULTIMA 2 is not protected
against liquids of any kind.
Never place containers of
liquid on ULTIMA 2. Never allow
ULTIMA 2 to come into contact with
moisture or liquids; doing so could
result in electrocution or damage to the
ULTIMA 2 internal circuitry.
Be aware that liquids, including water
that has dried, can leave minerals
that can a
ff
ect the PCB and other
components, which could eventually
lead to oxidisation and short-circuiting.
If the ULTIMA 2 comes into contact
with moisture or liquids, immediately
disconnect from the mains power
supply, and connected equipment, and
contact Chord Electronics for further
advice.
The ULTIMA 2 has internal
thermal protection that will cut
the power supply if reached.
Never operate the ULTIMA 2 near
sources of heat or naked flames as this
will decrease the lifespan of the internal
components. It is advised that you do
not operate the ULTIMA 2 in an area of
direct sunlight or on top of significant
heat- producing devices.
Please be aware that it is entirely
normal for the ULTIMA 2 to become
warm during use, particularly within
a stacked configuration. If you are
concerned about the temperatures,
please switch the device o
ff
and
consider a di
ff
erent placement.
