Chord Red Reference MK III, Руководство пользователя

Страница: 26 / 27

26
A-B
This function plays a particular section of your choosing in a loop between points A and B.
The selected section can be any length from a few seconds to several tracks.
When the disc is playing, press „A-B‟ to set the start point A, then let the disc continue to
your chosen end point and press „A-B‟ again to set point B. The transport will now play
only the information between points A and B, then back to A and so on. A-B will also
appear on the top panel display.
To exit this mode, press „A-B‟ for a third time and the disc will continue playing as
normal, or press STOP to stop the disc.
Trigger Outputs
The Red Reference features two trigger outputs that can be used to remotely trigger other
Chord equipment. The external trigger should be connected via a standard 1/8
th
inch /
3.5mm (mono or stereo) jack plug to the socket fitted to the rear of the unit.
The Red Reference should be switched off, the trigger lead inserted, then the unit switched
back on.
The connections are as follows:
The tip of the plug is the +5V to +12V dc connection, the centre and rear connection are
the 0V or ground connection.
IR Control
The third socket on the rear panel connects to the IR remote control receiver within the Red
Reference. When using room control systems you can connect the remote signal discretely
to this socket rather than using an external IR repeater stuck to the front panel display.
+5V to +12V
c. 0V / Ground