Chistie DLV, Руководство пользователя, Страница: 36 / 182

Section 3: Operation
3-6 Mirage S+/HD, Matrix S+/HD, Christie HD/DS+/DW, DLV User Manual
020-100001-05 Rev. 1 (12-2008)
Table 3.1. Auto Setup
What an “Auto Setup” Does
OPTIMIZES: SETS TO DEFAULT:
Pixel Tracking Contrast
Pixel Phase Brightness
Size and Blanking Auto Input Level (off)
Vertical Stretch Detail
(if video source)
Position Filter
Input Levels
Luma Delay
NOTE:
You must have an unlocked channel present to use Auto Setup.
Channel
Press
Channel
to select a specific source setup ( channel ) defined and stored in projector
memory. Once you enter a two-digit channel number (or, if there is a list displayed,
highlight it and press
), the display will automatically change and update
according to the numerous setup parameters defined for that channel. Note that a new
channel is automatically created if you adjust an image from a new source.
NOTE:
Channel (
Channel
) key behaviour during a presentation depends on whether or
not the Display Channel List option is enabled in the Menu Preferences menu. You
can choose to use a scrollable list of channels when you press
Channel
, or you may prefer
to enter the desired channel number “blind”, i.e., without on-screen feedback. See
Menu Preferences later in this section.
Input 1
Press
Input 1
to display from the data input source connected to BNCs labeled
INPUT 1
.
Input 2
Press
Input 2
to display from the DVI source connected to
INPUT 2
.
Input 3
Press
Input 3
to display from the composite video source connected to
INPUT 3
.
Input 4
Press
Input 4
to display from the S-video source connected to
INPUT 4
.
Input 5
Press
Input 5
to display from the
INPUT 5
interface module installed in the Option 1 slot.
NOTE:
If you have the optional Dual SD/HD-SDI Module installed and there are two
inputs connected here, the second input (B) is considered
INPUT 7.
If you are using the
built-in keypad or the remote keypad, press
INPUT 5
to access
INPUT 7
as follows:
•
While displaying from
INPUT 5
, press
Input 5
again. This switches to
INPUT 7
.
•
While displaying from any input other than the Dual SD/HD-SDI Module, press
Input 5
, this switches to either
INPUT 5
or
INPUT 7
, depending on which of the Dual
SD/HD-SDI Module inputs (A or B) was last used. Press
Input 5
again to display
from the other Dual SD/HD-SDI Module input.
Channel
Input 1
Input 2
Input 3
Input 4
Input 5