INSTALLATION
Location
When selecting a position for your Fridge/Freezer you should make sure the floor is flat and firm, and the room is well
ventilated. Avoid locating your Fridge/Freezer near a heat source, eg, cooker, boiler or radiator. Also avoid direct sunlight
in out-buildings or sun lounges. If you are placing your Fridge/Freezer in an out-building such as a garage or annex
ensure that the Fridge/Freezer is placed above the damp course, otherwise condensation will occur on the Fridge/Freezer
cabinet. When working, the refrigerator gives off heat to surroundings. Therefore, at least
300mm of free space should be spared at the top side, more than 100mm on both sides, and
above 50mm at the back side of the refrigerator.
Leveling the Fridge
If the Fridge is not level, the door and magnetic seal alignment will be affected and may cause
you Fridge to work incorrectly. Once the Fridge is placed in its final location, adjust the leveling
feet at the front by turning them.
Cleaning before use
Wipe the inside of the Fridge with a weak solution of bicarbonate of soda. Then rinse with warm water using a damp
sponge or cloth. Wash the baskets and shelves in warm soapy water and dry completely before replacing in the Fridge.
The external parts of the Fridge can be cleaned with wax polish.
Before plugging in YOU MUST
Check that you have a socket which is compatible with the plug supplied with the Fridge.
Before switching on!
DO NOT SWITCH ON UNTIL FOUR HOURS AFTER MOVING THE FRIDGE.
The coolant fluid needs time to settle. If the appliance is switched off at any time, wait 30 minutes before switching back on
to allow the coolant fluid to settle.
Before filling your Fridge
Before storing foods in your Fridge, turn the Fridge on and wait for 24 hours, to make sure it is working properly and to
allow the Fridge to fail to the correct temperature.
START
Testing
Clean the parts of the refrigerator with lukewarm water containing a little neutral detergent and with clear water, and wipe
them dry.
Notes:
Electric parts of the refrigerator can only be wiped by dry cloth.
1. Remark: turn the thermostat knob to the "4" position, turn on electricity. The compressor begin to work..
2. Open the door 30 minutes later, if the temperature in the refrigerator decreased obviously, it shows that the refrigerator
system works well. When the refrigerator operates for a period of time, the temperature controller will automatically set the
temperature within limits it opens.
Temperature Control Dial
Temperature Control
1.The temperature in the refrigerator compartment is controlled by the temperature controller installed on the back wall
of the refrigerator compartment.
2.Turn the thermostat knob to right or left, you can regulate the temperature inside the refrigerator.
3.The marks on the knob are the temperature grades, not the exact number of the degrees of temperature.”OFF” shows a
forced STOP and “7” shows the lowest temperature. Turn the knob from "1"position to "7"position, the temperature
decreases continuously. You may set the temperature control selector to any position according to what you need.
4.Please set the selector to "4" position in normal use.
STORAGE OF FOOD
1.How to Use the Refrigerator Compartment
*
The cook dishes can be put into refrigerator to keep fresh after their temperature decreases to room temperature.
*Egg pockets and bottle pockets for eggs, butter, milk and bottle drinks,etc..
2.Placement of Food
*Proper place should be left instead of too crowded during food storage.
*Food to be stored should be wrapped with clean plastic film or fresh keeping paper, then distributed to several frames
even to avoid contamination and the loss of water and smell mixture.
*Cool hot food down to the room temperature before storing or consumption of electricity will increase and would lead to
frost forming inside.
