Chippmann CS-8 DST2, Руководство пользователя, Страница: 9 / 16

CS-8 Series DST2 Rev1.0, Dec. 2018
-7-
AND EAR-DRUMS!
5. MAINTAINANCE/ CLEANING
•
BEFORE CLEANING THE PRODUCT, PLEASE DISCONNECT THE POWER
PLUG FROM THE OUTLET OR DISCONNECT THE MODULE FROM ITS
POWER CONNECTOR BY PULLING THE FLAT RIBBON CABLE.
•
USE A DRY OR SLIGHTLY MOIST CLOTH OR COMPRESSED AIR FOR
CLEANING. NEVER USE ANY CLEANER OR THINNER (E.G. PAINT THINNER
OR ACETON). PRINTS AND PAINTWORK WILL IMEDIATELY BE
DESTROYED!! ALSO AVOID ALCOHOL (ISOPROPYLIC), GAS, SPIRITS
(SCOTCH SINGLE MALTS, FOR A START) OR ABRASIVE HOUSEHOLD
CLEANERS!
6. GETTING STARTET
6.1 Unpacking
The box should contain the following items:
- 1 x CS-8 Series DST2 3HU rack-mount module
- 1 x Ribbon cable (20 cm length with two 16 pole IDC-connectors)
- 4 x M3 screws
- 4 x polypropylene washers
- this owners’ manual
If the content of the box turns out to be incomplete, please get in touch with
your dealer or
Schippmann electronic musical instruments immediately. In
case of damage caused in transit, please get back to the responsible carrier
and
Schippmann electronic musical instruments
immediately. We will support
you in this case.
6.2 Installation
Place the unit on a clean, d ry and sturd y surface, or use a suitable keyboard
stand or 19” rack. For 19” rack mounting, a suitable rack (3U Eurorack with +/-
12V power supply rails) is required. The CS-8 DST2 uses discrete all-analogue
electronics. We recommend placing the CS-08 DST away from heat sources