Chipcon CC400DB, Руководство пользователя

Страница: 4 / 19

SWRU068
4
2 CC400DB Demonstration Board
2.1 Before starting
The CC400DB runs on a 3.6V Lithium battery. If the battery is not mounted and
soldered to the board, insert the battery at the rear side of the board. Observe the LED. If
the LED is turned on continuously, push the “ON” button. For proper operation the LED
shall be pulsing with a period of approximately one second. If not, remove the battery
momentarily and reconnect. The battery terminals should be soldered for proper
operation.
Important: Be sure not to short-circuit the battery terminals during soldering or at any
point of use.
Before using the CC400DB: The use of radio transceivers is regulated by international
and national rules. Before transmitting a RF signal, please contact your local
telecommunication authorities to check if you are licensed to operate the transceiver.